SOP for Operation & Performance Check Procedure for Water Purification System

OBJECTIVE
To lay down the procedure for the Operation & Performance Check of the Puris water purification system for better and error-free use.

SCOPE
This procedure is applicable to the Puris water purification system installed in Q.C. Department at XYZ Limited

RESPONSIBILITY
Execution – Chemist and above -QC Department
Checking - Asst. Manager and above -QC Department


PROCEDURE
OPERATION PROCEDURE
  • Switch ‘ON’ the mains.
  • Switch ‘ON’ the instrument.
  • Open the valve for the RO water system
  • Press the UP ON/OFF Key for 5 sec
  • Press the UP ON/OFF Key again to produce the estimated amount of water
  • Press the menu key to stop working


PERFORMANCE CHECK PROCEDURE:


  • Operate the instrument as per the operating procedure mentioned above.
  • Take the required quantity of sample of water to perform the tests for determination of pH, conductivity, Total coliforms, Fecal coliforms, and for Total Viable Count
  • Record the results of the above-mentioned tests as per Annexure-1

Replacement of filter and membranes of Lab Water system and RO system
  • Filter and membranes of the Lab Water system & RO system shall be changed as per the frequency mention below and the record shall be maintained as per annexure-2


ABBREVIATION
SOP: Standard Operating Procedure
No. : Number
Dept. : Department
QC: Quality Control

ANNEXURE
Annexure No. - 1 -- Performance check report of water purification system
Annexure No. - 2 -- Filter/membrane replacement record

REVISION HISTORY
Nil

Post a Comment

0 Comments

Close Menu
close