SOP for Operating Procedure of Vernier Caliper

OBJECTIVE
To lay down a procedure for the operation of the vernier caliper

SCOPE
This procedure applies to the QC/production department in the Pharmaceutical Manufacturing Facilities of XYZ Limited.

RESPONSIBILITY
The Production staff and QA Supervisor are responsible for the implementation of the process.
The In-Charge is responsible for the execution and compliance of the procedure.

PROCEDURE
  • Before using the caliper, clean it using a lint-free cloth.
  • Install the battery at the front side of the vernier caliper.
  • Press the “ON/OFF” switch to put on the power.
  • Press the “ZERO” switch to adjust the zero set of the caliper. At this position, both the measuring jaws should touch each other.
  • Recheck and ensure the zero position is correct by moving the jaws using a thumb roller.


  • Press the “in/mm” switch and select the required unit range that is in inches or millimeters respectively.
  • Keep the object of which thickness has to be measured in between the jaws and note down the reading from the digital display.
  • Use the lower jaws for measuring the thickness, use the upper jaws for measuring the internal diameter, and for depth measuring, use the depth-measuring blade.
  • Repeat the same procedure for measuring other objects.
  • After usage press the “ON/OFF” switch to put off the power.
  • Clean the vernier caliper by using a lint-free cloth and keep it safely in box.

REFERENCE
Nil.

ABBREVIATION
Q.A: Quality Assurance
SOP: Standard Operating Procedure
No.: Number
P.D: Production

ANNEXURE
Nil.

REVISION CARD
Nil.

Post a Comment

0 Comments

Close Menu
close